Nortel Networks Passport ARN Routers - Manual (Page 38)

Installing and Operating Passport ARN Routers
1-14 114200-E Rev 00
Connecting to the STP Interface
To connect a token ring shielded twisted pair (STP) cable to the base module or
expansion module token ring interface:
1. Attach the 9-pin D-SUB plug to the token ring STP interface ( Figure 1-9 ).
Figure 1-9. Connecting a Token Ring STP Cable
2. Secure the token ring cable using the capture screws.
Connecting to the UTP Interface
To connect a token ring UTP cable to the expansion module token ring interface,
insert the RJ-45 connector into the UTP interface, as shown in
Figure 1-10 .
ARN0068A
COM3 COM4 COM5
COM
U
D
DD
B1
B2
RLSD Run
Boot
Fail
Pwr
RPS
Fan
Base
Adapter1
Adapter2
Expansion
DCM
PCMCIA
Advanced Remote Node
RLSD3
RLSD4
RLSD5
1
2
Serial
Serial
ISDN BRI
withNT1
STP RCVR
NSRT
WFLT
Token Ring 1
To
Token Ring
network
Token Ring STP cable
STP RCVR
NSRT
WFLT
Token Ring 2
Expansion module STP interface
Base module STP interface
UTP