Nortel Networks Passport ARN Routers - Manual (Page 115)

Using Local Boot (the Quick-Start Procedure)
114200-E Rev 00 B-9
Specify the version of RIP. The default
is to run RIP1. Rip2 runs RIP2 without
the automatic aggregation of subnets
that RIP1 provides. RIG2_AGGR
provices the automatic aggregation of
subnets for RIP2.
Enter Routing Protocol Number [1]:
1. RIP1
2. RIP2
3. RIP2_AGGR
OSPF Worksheet
Requested Information Options Your Response
Enter OSPF router ID in dotted
decimal notation: Enter an IP address to uniquely
identify the router in the OSPF
domain. The router provides the IP
address of the COM port.
We suggest using the default IP
address.
Enter the OSPF area ID in dotted
decimal notation [0.0.0.0]: Enter the area ID. This ID must
match the area ID of the router’s
neighbor.
Note: The backbone area ID is
always 0.0.0.0.
Enable Simple Password
authentication? (y/n) [n]: y(es)
n(o)
Note: If you answer y(es), the
router requests a password. Password:
______________
Follow default paths for unknown
subnets? (y/n) [n]: y(es)
n(o)
(continued)
RIP Worksheet (continued)
Requested Information Options Your Response