Nortel Networks Passport ARN Routers - Manual (Page 110)

Installing and Operating Passport ARN Routers
B-4 114200-E Rev 00
This worksheet lists specific options for RIP, OSPF, or Static Route
configurations. For example, if you select RIP as your routing protocol, you
need to fill out only the worksheet pertaining to RIP.
3. Fill out one Wide Area Protocol worksheet.
This worksheet lists specific options for Nortel Networks (proprietary)
Point-to-Point Protocol (PPP), frame relay, Standard PPP, and switched
multimegabit data service (SMDS) configurations. For example, if you select
frame relay as your wide area protocol, you need to fill out only the frame
relay worksheet.
4. Run inst_arn.bat as described in “Running the Quick-Start Script” on
page B-16 .
Or, a remote-site operator runs the installation script as described in this
guide.
5. When the router has an initial connection to the network, use the guide
Configuring Remote Access for AN and Passport ARN Routerse to
configure the router using Site Manager.