Philips CD245 - Manual (Page 26)

24 Use more of your phone
Press
r
key on the called handset
to answer the internal call, where
both internal callers can talk.
• Intercom is established.
Press
e
key on the first handset to
transfer the external call to the
called handset.
• The external call is transferred.
Note
If there is no answer from the called
handset, press
i
key to resume the
external call.
5.8.3 Answer an external call
during intercom
During intercom, a new call tone is
emitted when there is an incoming
external call.
Press
r
to answer the external call
and end the intercom.
• The call is established.
Note
To put the internal call on hold, press
i
key to answer the incoming external call.
5.8.4 Switch between an internal
and external call
During the call, press and hold
*
key
to switch between an internal or external
call.
5.8.5 Establish a three-party
conference call
The conference call feature allows one
external call to be shared with two
handsets (in intercom). The three parties
can share the conversation and no
network subscription is required.
During the call, long press
i
key
to put the external call on hold (the
caller can no longer hear you).
•
INT 23456 * is displayed,
representing the handset numbers
available for intercom
(
* represents all handsets).
Enter the handset number (key
2
-
6
) you wish to call for the
conference. To call all handsets at
once, press
*
key.
Press
r
key on the called handset
to answer the internal call, where
both internal callers can talk.
• Intercom is established.
Press and hold
i
key for 2
seconds on the first handset to start
the three-party conference.
•
CONFERENCE will be displayed on
the screen once the conference call
is established.
5.9 Paging
The paging feature enables you to locate
a missing handset if the handset is in range
and contains charged batteries.
Press
p
key on the base station.
• All the registered handsets start to
ring.
Once retrieved, press any key on the
handset to end the paging.
Note
If there are no key presses within 30
seconds, the handset and base station will
automatically return to idle mode.
3
4
1
2
1
2
3
4
1
2