Resetting the lamplife time, Maintenance, Lamp replacement resetting the lamplife time – Philips Garbo User Manual
Page 29: English user guide garbo
<
5
Unscrew screw B.
6
Grasp the lamp holder handle and carefully pull the lamp holder out of the projector.
•
Do not tilt. If the inner tube is broken glass particles may fall out.
•
Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening
at anyone.
7
Carefully remove the new lamp housing from its package.
•
Always use the same type of lamp: LCA3116/00 (132 W), 12nc: 8670 931 16009.
•
Do not touch lamp or point lamp housing opening at anyone.
•
Do not drop, as the impact may cause the lamp to break.
8
Place the lamp holder in the guiding slots and insert into the lamp compartment.
9
Tighten screw B again.
10 Put the lamp door back in place and press tab A back in its original position.
–
The Mains inlet socket will open again.
11 Insert the mains lead into both the projector Mains inlet socket and the wall socket.
12 Press the Standby button to switch on the projector.
13 Reset the lamp life time (see ‘Resetting the lamplife time’).
14 Dispose of the old lamp in special chemical disposal bins.
1
Press Menu.
–
The menu bar appears on the screen.
2
Use cursor control to select ‘Settings’ in the menu bar.
3
Use cursor control to select ‘Lamp counter’ in the sub menu.
4
Press OK for 3 seconds to reset the lamp counter.
5
If required, select another item you wish to adjust or press Menu to exit.
Lamp replacement
Resetting the lamplife
time
Philips Home Cinema Projector
English User guide Garbo
29
6. Maintenance
B
B
A
Display
Audio
Settings
Picture
(previous)
Start-up screen
Lamp counter
Auto standby
Auto source
Feedback
Lamp
0 hours
Lamp counter shows the operating hours of the
lamp. It is suggested to reset when a new lamp is
inserted. To reset keep OK key pressed
for 3 seconds.
Menu
OK
AV
Mute
Source
Stand
by
Lamp
Temp
Menu
OK
AV
Mute
Source
Stand
by
Lamp
Temp