Panasonic BT-LH2600W - Manual (Page 49)

49
REMOTE Specifications
(continued)
■
Priority of assigned functions
• When both “MARKER1” and “MARKER2” are activated at the same time, “MARKER1” has priority. However,
when the display aspect ratio is 4:3, the “MARKER1” aspect ratio is 16:9 and the “MARKER2” aspect ratio is 4:3,
“MARKER2” is displayed. In this case, the “MARKER2” background is controlled.
• When “MARKER BACK HALF” and “MARKER BACK BLACK” are activated at the same time, “MARKER BACK
BLACK” has priority.
• During GPI edge operation and two or more of “INPUT SEL. VIDEO”, “INPUT SEL. SDI1”, “INPUT SEL. SDI2”,
“INPUT SEL. YP
B
P
R
/RGB” and “INPUT SEL. DVI-D” are simultaneously activated, priority goes to the last
activated item. During level operation, priority is assigned in the following order: “INPUT SEL. VIDEO”, “INPUT
SEL. SDI1”, “INPUT SEL. SDI2”, “INPUT SEL. YP
B
P
R
/RGB” and “INPUT SEL. DVI-D”.
• When “GAMMA SEL. FILM” and “GAMMA SEL. STDIO/PST” are activated at the same time, “GAMMA SEL.
FILM” has priority.
The following diagram and the table on the lower right show RS-232C terminal pin arrangement and connections.
For details on systems using RS-232C, be sure to consult your dealer.
■
Connectors and signals
Connector: D-SUB 9-pin (female)
Signal
■ Communication parameters
■
Command format
• The command is the 3-character string starting with
STX and ending with ETX.
• Append any data after the colon (:) following the
command, as required.
■
Response formats
1. Setting command response
2. Query command response
3. Error response
Error codes
ER001: Invalid command
ER002: Parameter error
RS-232C terminal
PC Side (Straight) BT-LH2550 Side
RS-232C terminals (9P)
Pin number Signal Pin number Signal
1 N.C. 1 N.C.
2 RXD 2 TXD
3 TXD 3 RXD
4 DTR 4 DSR
5 GND 5 GND
6 DSR 6 DTR
7 RTS 7 CTS
8 CTS 8 RTS
9 N.C. 9 N.C.
RS-232C remote control method
Pin number Signal Description
1 N.C. Not connected
2 TXD Transmission data
3 RXD Reception data
4 DSR Connected inside
5 GND Ground
6 DTR Connected inside
7 CTS Connected inside
8 RTS Connected inside
9 N.C. Not connected
Signal level RS-232C compliant
Synchro system Asynchronous
Transfer rate 9600 bps
Parity None
Data length
8 bit
Stop bit 1 bit
Flow control None
STX (02h) Command : Data ETX (03h)
STX (02h) Command ETX (03h)
STX (02h) Data ETX (03h)
STX (02h) Error code ETX (03h)