Panasonic BT-LH2600W - Manual (Page 29)

29
Main Menu
(continued)
Underlined values indicate factory defaults.
*1 When the monitor is shipped, settings for “USER1” - “USER5” are identical to “FACTORY.”
*2 “H POSITION”, “V POSITION”, “PHASE” and “CLOCK” (
page 37) cannot be saved or loaded.
SYSTEM CONFIG
Sub menu Settings Description
B.LIGHT/CONT.
BACKLIGHT
CONTRAST Selects function to be assigned to BACKLIGHT/CONT. in the picture/
volume adjusting menu.
Adjusts the BACKLIGHT.
Adjusts the CONTRAST.
BACKLIGHT 0 - 50 Adjusts the backlight when the B.LIGHT/CONT. submenu is set to
CONTRAST.
MENU
POSITION CENTER
LB
RB
RT
LT Positions the on-screen menu.
Right Bottom
Right Top Left Top
STATUS
DISPLAY OFF
3SEC OFF
CONTINUE Sets display state for input signal status (on-screen menu).
Not displayed.
<3SEC OFF> Displayed for 3 seconds after a status change.
Displayed at all times
SETUP LOAD
USER5
*1*2
USER4
*1*2
USER3
*1*2
USER2
*1*2
USER1
*1*2
FACTORY
Loads saved factory defaults (FACTORY) or user data (USER1 - USER5).
After loading user data, the screen displays the signal selected before
user data was loaded.
SETUP SAVE USER5
*2
USER4
*2
USER3
*2
USER2
*2
USER1
*2
Up to 5 sets of user data can be saved ( page 20).
They save menu settings and adjustments made in the picture/volume
adjusting menu (PHASE/CHROMA/BRIGHT/CONTRAST/BACKLIGHT)
except “SETUP SAVE/SETUP LOAD.”
POWER ON
SETUP USER5
USER4
USER3
USER2
USER1
FACTORY
LAST Selects the settings used when the power is turned on.
Starts in the mode used when the power was last turned off.
Starts up using the factory defaults.
Starts up using USER registered settings.
POWER SAVE
MODE OFF
ON Sets the power save mode
Does not activate the POWER SAVE mode.
The backlight dims when no signal (NO SIGNAL) is input for 60
seconds or longer. Signal input or menu operation will return the
backlight to its normal brightness.
CALIBRATION Connect a CA-210 color analyzer and use this submenu to make a
calibration. It also returns calibration data to factory defaults. ( page 30,
31)