Panasonic AJ-D400 User Manual
Page 52
– 52 –
Status Displays Inside the Viewfinder Screen
1
Extender display
This is displayed when the lens extender is being used.
2
Shutter speed/mode display
This displays the shutter speed or shutter mode setting.
OFF:
The shutter is not used.
1/100, 1/120, 1/250, 1/500, 1/1000, 1/2000:
Shutter speeds (seconds) during standard mode.
1/30.4–1/250 (SYNCHRO SCAN):
Synchro scan mode is selected.
SUPER V:
High vertical resolution mode is selected.
3
Remaining tape length display
This indicates the remaining tape length (minutes) for the VTR during recording.
Remaining tape length display
Display
Remaining tape
length
F–60
60–55
55–50
50–45
45–40
40–35
35–30
30–25
25–20
20–15
15–10
10–5
5–0
Full to 60 minutes
60 to 55 minutes
55 to 50 minutes
50 to 45 minutes
45 to 40 minutes
40 to 35 minutes
35 to 30 minutes
30 to 25 minutes
25 to 20 minutes
20 to 15 minutes
15 to 10 minutes
10 to 5 minutes
5 to 0 minutes
The “5–0” display flashes when there is
less than 3 minutes of tape remaining.
4
Remaining battery level display
When an Anton Bauer Digital Magnum Series battery is used to supply power to the unit,
the remaining battery level is displayed numerically (%).
5
Filter display
This displays the type of filter selected.
6
White balance memory display
This displays the selected white balance automatic adjustment memory.
A:
The WHITE BAL switch is set to A.
B:
The WHITE BAL switch is set to B.
P:
The WHITE BAL switch is set to PRST.
7
Gain value display
This displays the image amplifier gain setting (dB) set by the GAIN switch.
|
Note
{
When using an Anton Bauer Digital Magnum Series battery, the remaining battery level display
continues to display the level for the Anton Bauer battery even if power supply is switched to an
external power source near the end of the battery’s power. However, note that the unit operates
according to the external power source.