Panasonic PT-D12000U - Manual (Page 110)

110 – ENGLISH
Using the Remote 2 terminal
Using the REMOTE 2 terminal provided on the connection terminals of the main unit, it is possible to operate the
projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot be
received.
Example of a control panel layout
Remote terminal External control
Remote terminal/External control
STANDBY ON
LAMP
RGB1
RGB2
VIDEO
S-VIDEO
Projector set up in a meeting room Control panel located in a different room
DVI-D
Pin assignments and control
Be sure to short-circuit Pins
1 and 9 when controlling.
Names of terminals Open (H) Short (L)
1
GND GND
2
POWER OFF ON
3
RGB1 Other RGB1
4
RGB2 Other RGB2
5
VIDEO Other VIDEO
6
S-VIDEO Other S-VIDEO
7
DVI-D Other DVI-D
8
SHUTTER OFF ON
9
RST / SET
Controlled by
remote control
Controlled by
external contact
D-Sub 9-pin (female)
external appearance
Note
The above figure shows the pin assignment and control details when “REMOTE2 MODE” (p. 80) is “DEFAULT”. •
When using “REMOTE2 MODE” with “USER”, the pin assignment and control details are those set for “USER”.
When pin •
1 and pin 9 are short-circuited, the following buttons on the projector's control panel and on the
remote control cannot be used.
POWER button, SHUTTER button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used
either.
When pin •
1 and pin 9 are short-circuited and then any one of pins 3 to 7 is short-circuited to pin 1, the
following buttons on the projector's control panel and on the remote control cannot be used.
POWER button, input selection buttons (RGB1, RGB2, DVI-D, AUX, VIDEO, S-VIDEO), SHUTTER button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used
either.