Panasonic AJ-D92P - Manual (Page 27)

27
Recording
How set to the user’s bit
By setting the user’s bit, a memo (time or date) or
other information using up to 8 hexadecimal digits can
be recorded on the sub-code track.
Concerning the user’s bit memory function
The user’s bit setting is automatically stored in the
memory and retained even when the unit’s power is
turned off.
When TIME or DATE has been selected with the UB
MODE setting, the date or time which was set using
setup menu item No. 540 (TIME/DATE) is entered in
the user’s bit.
Set the DISPLAY switch to the UB position.
1
Set the TCG selector switch to the SET
position.
2
Select USER as the setup menu item No. 530
(UB MODE) setting.
3
Set the user’s bit using the SHIFT button as
well as the “+” and “–” buttons.
SHIFT button:
This causes the digit to be set to flash.
Each time it is pressed, the flashing digit
moves to the right.
“+” button:
This increases the flashing digit by 1.
“–” button:
This decreases the flashing digit by 1.
4
O A through F in hexadecimal notation are displayed as
shown in the table below.
1 2 4
O
When TIME is selected, the hours, minutes and
seconds are entered in the user’s bit.
O
When DATE is selected, the year, month, day and
hours are entered in the user’s bit.
Hexadecimal notation
Display
A B C D E F