Panasonic DMR-E20 - Manual (Page 34)

34
TV
TV/AV
PROG / CHECK
TOP WINDOW
TV/TEXT
STOP
SV/V+
REC
TIME SLIP
AV LINK
SETUP
AUDIO
REC MODE CANCEL
INPUT
SELECT
MANUAL
SKIP
LAST
MARKER
DIRECT
TV REC
TIMER
REC
1 2 3
4 5 6
7 8 9
0
PAUSE PLAY
STATUS
RETURN
VOL
OPEN/CLOSE
T C E R I D
R O T A G I V A N
TO
P M EN
U M
E N U
DISPLAY
T SI L
Y A L P
ENTER
TV DVD
TV ASPECT
FRAME
SKIP SLOW/SEARCH
Á
4
5
/
5
Timer recording (continued)
4 Press [ENTER] when you have finished making changes.
≥To continue programming:
Repeat steps 2, 3, and 4.
5 Press [PROG/CHECK] or [RETURN].
ªFlexible recording mode (FR)
≥The unit automatically selects a recording mode between “XP” and “EP” that will enable the
timer recording to fit in the available recording time on the disc with the best possible recording
quality.
≥This only works with timer recordings.
≥It may not be possible to record to the finish of the programme if the remaining time doesn’t
allow.
≥This does not work with VPS/PDC.
To put the unit on recording standby
Press [ Á, TIMER REC].
Ensure “ Á” lights on the unit’s display.
To change the timer recording programme
1) While the Timer Programme List Screen is being shown, use the joystick [ 3, 4] to select the
programme you want to change, and press [ENTER] to show the Timer Programme
Correction screen.
2) Move through the items with the joystick [ 1] and change the settings with the joystick [3, 4]
and press [ENTER].
To clear a timer recording programme
Press [CANCEL] while the programme’s Timer Programme Correction screen is being shown.
Alternatively, use the joystick [
3, 4] to select the programme in the Timer Programme List
screen and press [CANCEL].
≥You can not delete programmes that are currently recording.
Note
≥If the disc is protected or full, the unit switches to standby but does not go on standby for
recording. Check the disc carefully.
≥The built-in clock employs 24-hour system.
≥The remaining time is not shown if you insert discs other than DVD-RAM or DVD-R.
≥The remaining time displayed is calculated based on the current recording mode.
≥Approximetely 30 seconds at the beginning of subsequent programmes is not recorded when
you used recording to record multiple programmes to a DVD-R.
≥Recording is not possible unless you set “Disc Protection“ in “DISC INFORMATION“ to “Off“.
≥You cannot record to a disc if the write protect tab on a cartridge disc is set to protect. Release
this before operation (page 91).
≥If the unit is not put in the timer recording standby mode at the latest 10 minutes before the
programmed timer recording starting time, the [ Á] flashes on the unit display. In this case,
press the [ Á, TIMER REC] button to put the unit in the timer recording standby mode.