Pride Mobility jazzy 1120 - Manual (Page 32)

32 Jazzy 1120
2000
V I I I . O P E R A T I O N
To arm the lockout system:
1. Hold the magnetic key on or near the key symbol. The controller beeps and automatically powers down. No
LEDs should be on.
2. Press the on/off key to power up the chair. The key LED flashes, but you will not be able to drive the power
chair because the controller is still locked.
3. Hold the magnetic key on or near the key symbol again to unlock the system. When the key LED stops
flashing, you may drive your Jazzy.
If you turn on the controller while it is locked and don’t unlock it after one minute, the controller automatically turns
itself off.
On/Off Key
This key switches the system power on and off.
Horn Key
This key activates the horn.
System Status Indicator
This LED indicates system status. It is normally on when the system is powered up and off when the system is
powered down. It also flashes trouble codes when the system detects a fault. See “Trouble Codes.”
Drive Mode Select Key
This key enables you to select a drive program. This mode also consists of a seven-segment LED that displays the
drive program. It also displays whether or not the inhibit is enabled and flashes if there is an OONAPU or DX/
Remote fault. See “Out Of Neutral At Power Up.”
Drive Mode Indicator (not shown)
Your Jazzy controller was pre-programmed at the factory for five drive modes: 1 (slowest) to 5 (fastest). The
program mode is indicated by a number in the center of the keypad. Press the Drive Mode Select Key to change
the mode.
NOTE: We recommend that the first few times you operate your Jazzy you have your drive mode on the
slowest setting until you to become familiar with your new powered wheelchair.
BATTERY SAVER FEATURE
When the battery capacity drops to below 21V (typically two LEDs), the controller reduces wheelchair perfor-
mance to conserve battery power.