Philips CPWBS001 - Manual (Page 13)

Attach to Your Network Using Ethernet Cabling
The four Local Network ports 1, 2, 3 and 4 on the Wireless Base Station
auto-negotiate the connection speed to 10 Mbps Ethernet or 100 Mbps
Fast Ethernet, and the transmission mode to half duplex or full duplex.
Use twisted-pair cable to connect any of the four Local Network ports 1, 2,
3, and 4 on the Wireless Base Station to an Ethernet adapter on your PC.
Otherwise, you can cascade any of the Local Network ports 1, 2, 3, and 4
on the Wireless Base Station to an Ethernet hub or switch, and then
connect your PC or other network equipment to the hub or switch. When
inserting an RJ-45 plug, be sure the tab on the plug clicks into position to
ensure that it is properly seated.
Warning: Do not plug a phone jack connector into any RJ-45 port.This may damage
the Wireless Base Station. Instead, use only twisted-pair cables with RJ-45
connectors that conform with FCC standards.
ENGLISH 13