Promise Technology SuperSwap 4600 User Manual
Page 16
SuperSwap 4600 User Manual
10
12. Connect three of your computer’s internal power cables to the power
connectors on the back of the SuperSwap enclosure.
Provide a direct connection to the power supply for all three SuperSwap
power connectors.
13. Set the Sequential Startup switch to ON. See “Sequential Startup Option” on
14. Replace the computer’s cover and reinstall the power cord.
Cautions
•
Promise Technology recommends that you compare the
capacity of your Power Supply against the wattage required
by your PC plus the disk drives you plan to install in the
SuperSwap 4600. Upgrade your Power Supply if necessary.
•
Do not use a Y-connector to share power between the
SuperSwap 4600 and another device or to share power
among the three power connectors on the SuperSwap 4600.
Power
Connectors
Sequential
Startup Switch