Promise Technology SuperSwap 4600 - Manual (Page 11)

5
Chapter 2: Installation
• Unpack your SuperSwap 4600 (below)
• Install the Enclosure (below)
• Install a Disk Drive (page 11)
• Remove a Disk Drive (page 14)
Unpack your SuperSwap 4600
The SuperSwap 4600 box contains the following items:
There are two phases to install the SuperSwap 4600 into your computer:
• Install the enclosure in your computer chassis
• Install a disk drive in the drive carrier
Install the Enclosure
To install the enclosure in your computer chassis, follow these steps:
1. Power down your computer and unplug the power cord.
2. Remove the computer cover.
3. Arrange the drive assemblies to arrange for three contiguous, free 5.25-inch
drive bays. Remove any bezels covering them.
• SuperSwap Drive Enclosure
• (4) Drive Carriers
• Quick Start Guide
• 3-pin to 3-pin SMBus Cable
(SATA II compliant)
• 6-pin to 6-pin Daisy Chain Cable
• (16) Screws to attach 3.5-inch
disk drives to drive carriers
• (16) Screws to attach 2.5-inch
disk drives to drive carriers
• (8) Screws to mount Enclosure
into PC chassis
• Product CD with User Manual
Warning
SuperSwap 4600, like other parts of your system, is subject to
damage by static electricity. Be sure that you are properly
grounded (Promise recommends that you wear an anti-static strap
or touch a grounded object) and that you unplug your system
before installing SuperSwap 4600 or handling its components.