Planet Technology WDAP-2000PE - Manual (Page 52)

Description: Set the HTTP server port (for device management) to the one specified.
set http timeout
Description: Set the timeout value for the HTTP management session.
set prompt
Description: Set the command line prompt.
set system contact
Description: Configure a string describing the system contact information. This is the value of
the SNMP system contact MIB.
set system ip
Description: Set the IP address for the device LAN interface.
set system location
Description: Configure a string describing the system location information. This is the value of
the SNMP system location MIB.
set system name
Description: Configuring a string for the system name. This is also the value of the SNMP
system name MIB.
set telnet port
Description: Set the TELNET server port (for device management) to the one specified.
set telnet timeout
Description: Set the timeout value for a TELNET management session.
show arp table
Description: Display the ARP table of the system.
show http
Description: Display the current configurations of the HTTP management function.
show system
Description: Display the current basic system configurations.
show system ip
Description: Display the current device IP settings of the system.
show telnet
Description: Display the current configurations of the TELNET management function.
show upnp
Description: Display the current configurations of the UPnP function.
show wlan management
Description: Display the current state of WLAN management.
(2) Filtering Commands
add mac filter
Description: Add a MAC filter with the specified name (a mnemonic name) and MAC address.
delete mac filter
Description: Delete the MAC filter with the specified name.
set mac filter mode
Description: Set the MAC filter mode.
show mac filter []
Description: Display the MAC filter entry with the specified name. If no name is specified, this
command display all currently configured MAC filter entries.
show mac filter mode
Description: Display the currently configured MAC filter mode.
(3) SNMP Commands
disable snmp
Description: Disable the SNMP function.
enable snmp
Description: Enable the SNMP function.
set community string {read | write}
Description: Configure the SNMP READ/WRITE community string.
show community string read
Description: Display the SNMP READ community string.
show snmp
Description: Display the current SNMP settings.
50