Planet Technology WDAP-2000PE - Manual (Page 26)

Fragmentation
When the size of a unicast frame exceeds the fragmentation
threshold, it will be fragmented before the transmission. It should
have a value of 256-2346 bytes, with a default of 2346. If you
experience a high packet error rate, you should slightly decrease
the Fragmentation Threshold.
DTIM interval
The WDAP-2000PE buffers packets for stations that operate in
the power saving mode. The Delivery Traffic Indication Message
(DTIM) informs such power conserving stations that there are
packets waiting to be received by them. The DTIM interval speci-
fies how often the beacon frame should contain DTIMs. It should
have a value between 1 to 255, with a default value of 1.
User limitation
Set the number of users allowed to get associated with your
WDAP-2000PE.
Enable privacy seperator
Enable Privacy Separator will make any two WLAN stations on
different networks unable to see each other.
Radio 1/Radio 2 Transmit
Power
This is the power degree in percentage (max.: 100%) that ra-
dio1/radio2 uses to transmit data.
Rate control
This is the maximum or fixed data rate to transmit data supported.
Age out timer
If a station does not send anything in age out time, a empty date
frame will be sent to the station, If this frame is not ACKed, the
station will be disassociated and then deauthenticated.
3.5.7 Operational Mode
Select a Radio to config-
Currently, each radio of the WDAP-2000PE can be configured to
operate in AP or WDS mode. When configured as a WDS, you
need to further configure the name and MAC address of its peer
24