Pitney Bowes DM1000 - Manual (Page 48)

4
SV60951 Rev. A 4-15
DM1000 Operating Guide
How To Run Mail in the Attached Scale-AutoTape Mode
1. Verify that the Trip Weight value is correct or change if
necessary. Each mailpiece must be no less than this value.
(See 5 - Mailing System Setup, Setting the Differential Weigh
Trip Weight).
2. Check that the AutoScale feature set to On (See 5 - Mailing
System Setup, Scales/Rates in this guide).
3. Press the Mode key.
4. If the Attached Scale-Auto Tape mode is not listed, select
Weighing Options.
5. Select Attached Scale-AutoTape.
The “Print Tape Automatically” screen appears.
6. Press the Class key to choose a class if you have not done so.
If more than one carrier is available for the class you select,
use the right arrow key to compare the rates.
7. Select Account and follow the prompts. (For further details,
see Selecting/Deselecting an Account to Print Postage.)
8. Move the tape lever up for wet tape and down for dry or
pressure-sensitive tape.
9. Place each piece of mail, one at a time, on the scale. The
system prints a tape each time you place another piece of mail
on the scale.
The AutoTape mode is designed to save you time when you have several
pieces of mail that need to be weighed as well as have tapes printed. In
this mode each time a new weight is placed on the attached scale, a tape
with the correct postage automatically prints out.
Mode:
Attached Scale-
AutoTape
Use the Attached Scale-AutoTape if:
• You are processing several pieces of mail and need to
weigh the mail and print tapes.