POLAR SMARTEDGE - Manual (Page 8)

13 12
Setting age
1. From the display showing USER, press SET/START/STOP to
enter the user information loop and to change its settings.
AGE appears, the digit for tens of years is flashing.
2. Press SIGNAL/LIGHT to adjust the value for tens of years.
3. Press SET/START/STOP to lock your selection.
The digit for years begins to flash.
4. Press SIGNAL/LIGHT to adjust the value for years.
You have now set your age.
Setting weight
1. In the USER setting loop, press MODE to set your weight.
KG appears, the digit for hundreds of kilos is flashing.
Select the weight unit between KG and LBS
by pressing and holding SET/START/STOP
for two seconds.
2. Press SIGNAL/LIGHT repeatedly to adjust the value
for hundreds of kg/lbs.
3. Press SET/START/STOP to lock your selection.
The digit for tens of kg/lbs is flashing.
4. Press SIGNAL/LIGHT to adjust the value for tens of kg/lbs.
5. Press SET/START/STOP to lock your selection.
The unit for kg/lbs is flashing.
6. Press SIGNAL/LIGHT to adjust the unit value for kg/lbs.
You have now set your weight.
Setting sex
1. In the USER setting loop, press MODE again to set your sex.
SEX appears, MALE is flashing.
2. Press SIGNAL/LIGHT to select the right sex.
You have now set all necessary user information.
Setting User
Information and
Measurement Options
SET
USER O.Z. LIMIT KCAL HELP
AGE KG/LBS SEX O.Z.V/O.Z.A
In the Set mode you can define your personal user information
and determine the options which are used during heart rate
measurement.
At any time of the settings you can return to the Set mode by
pressing MODE until you see SET on the display.
You can move on even though some digit is blinking on the
display. The latest displayed values will be saved.
The settings of user information and measurement options are
a prerequisite for the use of Polar SmartEdge’s unique
OwnZone and OwnCal features.
USER SETTINGS
Polar SmartEdge needs information about you to calculate
your OwnZone and OwnCal calorie consumption.
Begin with the display showing the Time of day.
1. Press MODE three times to enter the SET mode.
2. Press SET/START/STOP to enter the setting loop.
USER is displayed.