POLAR SMARTEDGE - Manual (Page 7)

11 10
3. Press SIGNAL/LIGHT repeatedly to adjust the desired hour.
4. Press SET/START/STOP to lock your selection.
The tens of minutes start flashing.
5. Press SIGNAL/LIGHT repeatedly to adjust the desired
tens of minutes.
6. Press SET/START/STOP to lock your selection.
The seconds go to zero.
The minutes start flashing.
7. Press SIGNAL/LIGHT repeatedly to adjust
the desired minutes.
8. Press SET/START/STOP to lock your selection.
You have gone through the time setting function.
The seconds start running.
AM/PM or the hours start flashing.
9. Press MODE and move onward to set the date.
SETTING THE DATE
The date follows the structure YearMonthDay.
The digit for the tens of years is flashing.
1. Press SIGNAL/LIGHT to adjust the desired value for
the tens of years.
2. Press SET/START/STOP to lock your selection.
The digit for years starts to flash.
3. Press SIGNAL/LIGHT to adjust the desired value for the year.
4. Press SET/START/STOP to lock your selection.
The digit for month starts to flash.
5. Press SIGNAL/LIGHT to adjust the desired value for the month.
6. Press SET/START/STOP to lock your selection.
The digit for day starts to flash.
7. Press SIGNAL/LIGHT to adjust the desired value for
the day. You have gone through the date setting function.
The digit for day is flashing.
8. Press MODE and return to the Time of Day mode.
SETTING THE ALARM TIME
In the Time of Day mode, press SET/START/STOP.
Alarm symbol • is flashing.
1. Press SIGNAL/LIGHT to select whether you want
the alarm on or off.
Alarm is on
• Alarm is off
2. Press SET/START/STOP to lock your selection.
AM/PM starts to flash.
In 24h mode the hours flash > step 5
3. Press SIGNAL/LIGHT to select AM or PM.
4. Press SET/START/STOP to lock your selection.
The hours start to flash.
5. Press SIGNAL/LIGHT repeatedly to adjust the desired hour.
6. Press SET/START/STOP to lock your selection.
The tens of minutes start flashing.
7. Press SIGNAL/LIGHT repeatedly to adjust
the desired tens of minutes.
8. Press SET/START/STOP to lock your selection.
The minutes start flashing.
9. Press SIGNAL/LIGHT repeatedly to adjust the desired
minutes. You have gone through the alarm setting function.
The minutes are flashing.
10. Press MODE and move onward to set the time.
When the alarm sounds, it will remain on for one minute
unless you turn it off earlier by pressing any of the
three buttons of the wrist receiver.
SETTING THE TIME OF DAY
AM/PM (In 24h mode the hours) is flashing.
1. Press SIGNAL/LIGHT to select AM or PM.
2. Press SET/START/STOP to lock your selection.
The hours start to flash.