Paxar Monarch 917 - Manual (Page 20)

4. Press E when the number you need appears. Press
e twice to exit to the Main menu.
C u t P o s i t i o n
This function adjusts where the tag is cut. The printer adjusts the
cut position according to the black marks on the supply. You may
need to adjust for aperature supplies. Increase to move the cut
up; decrease to move the cut down.
To change the setting, from the Main Menu, select Setup, then
Supply. Then, follow these steps.
1. Press L or R until you see
SUPPLY
l Cut Pos r
2. Press E. You will see the current setting, for example:
Enter knife adj
[-300/300]: +0
3. Press L or R to change the cut position. Pressing L
decreases the value (moves the cut down); R increases it
(moves the cut up).
4. Press E when the number you need appears. Press
e to exit to the Setup menu.
2-8 Setting Supply Options