Paxar Monarch 9855 - Manual (Page 20)

16
Problem Action
Blank labels print or 750
series errors.
Clean supply sensors.
Printer does not read or
program the RFID tag.
See your System Administrator. Make sure the
following are set correctly for your inlay (RFID tag)
type: Protocol (Class 1, Class 0+, etc.), Read
Power, and Write Power. Refer to your RFID
Setup Guide & Supply Chart for more information.
C o m m o n E r r o r s
If the action does not resolve the problem, call Technical Support at the number
listed on the inside front cover of this manual.
Error Description/Action
002
Name must be 1 to 8 characters inside quotes.
005 Supply width is invalid.
018 Code page selection defined in the field is invalid.
025 Data length is too long.
052 Data type in the RFID Data Field must be 0, 1, 2, or 3. See your System
Administrator for more information.
101 Format referenced by batch not in memory.
400 Invalid character following {.
403 Field separator was not found.
409 Printer memory is full. Delete unnecessary formats or graphics from
memory.
410 Parity mismatch.
411 Framing error (baud rate mismatch).
412 Flow control mismatch.
413 Online receive buffer is full. Check for a flow control problem.
611 Font, bar code, or density in the batch does not fit the format.
612 The data in this line of the batch is either missing or does not match the
format.
613 Reference point off supply.
614 Portion of field off supply or there may be an invalid character in the
packet.
703 The printer sensed a calibration of different-sized black marks. Make
sure the correct supply type is loaded.