Pioneer PDP-5080HD - Manual (Page 17)

17
En
Preparation 05
Englis
h
Note
• Before installing the speaker, make sure that the Pioneer table
top stand is attached to the plasma display.
1 Attach the speaker mounting fittings to the rear
of the plasma display.
• Attach the fittings for right and left sides to the bottom
right and left on the rear panel of the plasma display using
the supplied screws.
• Attach the fitting for center to the lower center on the rear
panel of the plasma display using the two supplied screws.
PDP-5080HD with the speaker installed
(with the Pioneer table top stand)
Speaker mounting fitting
(side)
Speaker
Speaker mounting fitting
(center)
Speaker cable
Speaker mounting fitting
(side)
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm)
Bead band
➁ Then, tighten the
screw in the screw
hole right under the
upper hole.
Speaker mounting fitting for side
(It shows the attachment of the fitting on
the left side. It is attached on the right
side by the same procedure.)
Speaker mounting screw
(M5 x 10 mm)
➀ Tighten the screw in
the upper screw hole
first.
Speaker mounting fitting for center
➁ Then, tighten the screw
in the oval-shaped screw
hole.
➀ Tighten the screw
in the round-
shaped hole first. Speaker mounting screw
(M5 x 10 mm)
PDP5080HD.book Page 17 Monday, April 9, 2007 7:49 PM