Philips CEM200 - Manual (Page 9)

10
Connection: for cars with ISO
connectors
Caution
Ensure that all loose leads are insulated with ‡
electrical tape.
1
Pull out the ISO connectors from car
dashboard and connect them to the
bigger end of the supplied standard
connector.
2
Connect the other end of the supplied
standard connector to the unit.
3
&RQQHFWWKHDQWHQQDDQGDPSOLÀHUDV
illustrated, if applicable. You can connect
WKHFDUDXGLRWRWKHDPSOLÀHUWKURXJK
RCA-TO-RCA cables (not supplied).
Note on the power supply lead (yellow)
When you connect other devices to this ‡
apparatus, ensure that the rating of the
car circuit is higher than the total fuse
value of all the connected devices.
Notes on speaker connection
Never connect speaker wires to the ‡
metal body or chassis of the car.
Never connect speaker wires with stripes
‡
to one another.
Overview of parts
These are the supplied parts needed to
connect and install this unit.
a In-car audio system
b Sleeve
c Front panel
d Trim plate
e Rubber cushion
f Disassembly tools
g Screws (4 pieces)
h ISO connector
a b
c
e f g h
d
EN