Polycom HDX Systems - Manual (Page 28)

U SER ’ S G UIDE FOR P OLYCOM HDX S YSTEMS
WWW . POLYCOM . COM / VIDEODOCUMENTATION
24
About Multipoint Viewing Modes
What you see during a multipoint call can vary depending on how the Polycom
HDX system is configured, the number of sites participating, and whether
content is shared. The multipoint viewing mode configured on the host system
is the one used in the call. The following table describes the different
multipoint viewing modes.
Setting Description
Auto Allow the system to switch between Discussion and
Presentation modes, based on the interaction between the
sites.
ƒ If more than one site is talking at the same time, the
system uses Discussion mode so that all speakers can be
seen.
ƒ If one speaker talks without interruption for about 15
seconds, the system uses Presentation mode so that all
participants can see the speaker in a larger picture.
Discussion View all of the sites at the same time, including your own site.
This is also known as continuous presence.
Systems with: See this:
Single monitor All sites, each in its own window
Dual monitors Speaker on second monitor with other
sites on first monitor, or one far site on
each monitor
Presentation View the person who is speaking. This is also known as voice
activated switching.
The current speaker always sees up to four far sites, each in its
own window, on the first monitor.
Systems with: See this:
Single monitor Speaker in full screen
Dual monitors Speaker on the first monitor and near site
on the second monitor
Full Screen Enable every site in the call to see the speaker full screen. The
current speaker sees the previous speaker.