Polycom 4400 - Manual (Page 7)

Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs
PN: 1725-36192-001_H 7
Section 1: Configuration for SVP Operation
Network Topology
SIP PBX
TFTP Server, DHCP Server
RADIUS Authentication Server
(for WPA2-Enterprise Security)
Wireless Data Client
SpectraLink 8000 series
Wireless Telephones
Cisco 4400 Series WIRELESS LAN CONTROLLER
MODEL 4402 50 AP CONSOLE
STATUS ALARM PS1 PS2 LINK ACT
SERVICE
LINK ACT
UTILITY 1 2
LINK ACT
Cisco WLC
Cisco AP
Cisco AP
SVP Server
This configuration is not applicable to all customer environments.
Configuring a New Controller Starting from Factory Defaults
1. Initial provisioning of the controller is done via the command line
interface (CLI). Connect a null modem serial cable between the
console port of the controller and the serial port of a PC.
2. Open a terminal program, such as Hyper Terminal, and configure the
port settings to 9600 baud, no parity, 8 data bits and 1 stop bit.