Polycom 4400 User Manual

Page 13

Section 1: SVP

Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs

PN: 1725-36192-001_H

Global settings for

RF Channel Assignment

and

Tx Power Level

Assignment

were not tested. For

Custom

Power

and

Channel

setting

s please consult your facility’s RF site survey — optimized for

wireless voice traffic

— to determine correct power and channel

settings for each AP using only channels

and

4. Set

Admin

Status

Enable

5. Configure any other settings that might be relevant to your

deployment as needed.

6. Click the

Apply

button to save all changes.

Screenshot for 1100, 1130, 1200, 1230 and 1240 series access points:

Screenshot for 1140 and 1250 series access points:

7. In the navigation pane under

802.11b/g/n

, click

Network

8. Set

802.11b/g Network Status

Disable

. The radio will be re- enabled

after setting radio parameters.

For setting up the

Data Rates,

please consult your facility’s RF site

survey, designed for voice traffic, to determine if you have sufficient
coverage to support all data rates. SpectraLink Wireless
Telephones require the following minimum dBm reading to support
the corresponding

Mandatory

data rate setting in the access point.