Patton electronic 1092ARC - Manual (Page 8)

MAIN MENU Option 1: Display Active Configuration
Select Option 1 to display the most recent configuration of the local
Model 1092ARC (See below). The Model 1092ARC uses the active
configuration for its operation. If you make changes to the
configuration, you must select MAIN MENU Option 8. This will update
the unit to the new active configuration.
MAIN MENU Option 2: Display Hardware Configuration
Select Option 2 to display the configuration of the hardware DIP-
switches. To use the Hardware Configuration for the Active
Configuration, select
MAIN MENU Option 5. Then select “Use
Hardware DIP-Switches”. Finally, select MAIN MENU Option 8 to save.
MAIN MENU Option 3: Display Software Configuration
Select Option 3 to display the configuration of the software
switches. To use the software configuration for the Active
Configuration, select
MAIN MENU, Option 5. Then select “Use
Software Switches”. Finally, select MAIN MENU Option 8 to save.
14
4. To make a selection from any menu, enter the option number.
To exit any menu without making a selection, press the [ESC]
key.
5) After the Model 1092ARC is powered on, the control port will
send out this message:
Model: 1092ARC software version xx
Patton Electronics Copyright © 2000
6) Press [ESC] on the terminal.
7) The 1092ARC will then display the MAIN MENU screen. You
may configure the LOCAL Model 1092ARC from this screen.
3.2.1 Configure the Local 1092ARC
To configure the LOCAL 1092ARC, make a selection from the following
MAIN MENU.
13
Important!!: To make a selection from any menu, enter
the option number. To exit any menu without making a
selection, or to return to the previous menu, press the
[ESC] key.