Pentax Optio E60 - Manual (Page 21)

19
1
Getting Started
Powering the Camera
Install the batteries into the camera. Use two AA alkaline, AA lithium, AA
Ni-MH, or AA nickel manganese batteries.
1
Open the battery/card cover.
Slide the battery/card cover in the direction 1. The cover will automatically
open in the direction 2 when you release your fingers from it.
2
Insert the batteries, making sure the (+) and (–)
terminals on the batteries match the (+) and (–) symbols
inside the battery compartment.
3
Close the battery/card cover and slide it in the opposite
direction of 1.
Installing the Batteries
• AA alkaline, AA lithium and AA nickel manganese batteries are not
rechargeable.
• Do not open the battery/card cover or remove the batteries while
the camera is turned on.
• If you do not intend to use the camera for a long time, remove the batteries.
If the batteries are left in the camera for a long time, they may leak.
• If the batteries have been removed from the camera for a long time,
when they are reinserted and the camera is turned on, the message
[Battery depleted] may appear. This can also happen when using
the camera for the first time; however this is not a malfunction. Turn
the camera off, wait a minute and then turn the camera on again to
reset the camera. The date and time may also be reset.
• Insert the batteries correctly. If the batteries are incorrectly
oriented, malfunction may result. If the ends of the batteries look
dirty, wipe them before inserting into the camera.