Planar C3215 - Manual (Page 52)

What happens What to do
System does not power-up Check AC power receptacle.
Check plug into power adapter.
Check plug into Clean Screen II head.
Check fuse.
Power-on light does not go on If the system is operating normally, the light
may be defective.
Prompt doesn’t appear after system boots See Problems at Initial System Start-up.
System halts before completing POST This indicates a fatal system error that requires
immediate service attention. Note the screen
display and write down any beep code emitted.
Provide this information to your service repre-
sentative.
Appendix C: Troubleshooting
41
CS II Manual LAYOUT#2304 3/25/99 11:16 AM Page 41