Planar C3215 - Manual (Page 18)

Installing Memory
Figure 9
Do not remove the T-Bar or standoffs.
To remove a memory module
1. Remove back housing as above.
2. Placing your hands on both sides of the T-Bar, gently open both side catches simultaneously
(apply pressure to the plastic part of the catch, not the metal spring).
3. The module will pop up.
4. Remove the memory module.
To install a memory module
1. Remove back panel as above.
2. Placing your hands on both sides of the T-Bar, gently insert the memory module into the
empty socket. Ensure correct orientation using the module notch located next to the contacts.
3. Push the module down gently until the side catches snap up into place, coaxing them if
necessary.
Technical Note: The memory module will only insert one way into the socket; do not force
it. If you meet with resistance, check the orientation of the module.
For correct memory configuration, see table on the following page.
Chapter Three: Hardware Installation and Replacement
7
Memory Slot with Memory Installed
CS II Manual LAYOUT#2304 3/25/99 11:16 AM Page 7