Pentax MZ-6 - Manual (Page 24)

UNLOADING FILM
37
BASIC
B
ASIC OPERA
TIONS
36
eAfter setting the ISO speed, set the
mode dial to any position other than
[ ISO].
SETTING THE FILM SPEED (ISO) MANUALLY
The camera automatically reads the film speed from the
film’s DX code. However, the film speed setting can be
changed. If you use a non-DX coded film, set the film
speed manually.
1
Load the film.
qLoad the non-DX-coded film.
2
Setting the ISO speed
qSet the mode dial to [ISO].
wMove the select switch to set the ISO
speed.
• The ISO speed can be set from ISO 6
to 6400 in 1/3-EV increments.
• [ISO] is displayed when the film speed
is set manually for the DX-coded film.
Memo Memo
MZ-6(E)03 C/021-044 11/8/02 11:57 AM Page 36