Pentax MZ-6 - Manual (Page 15)

4
Align the film leader with the
film leader end mark and make
sure that the film leader is posi-
tioned under the film retainer as
shown in the illustration.
• If the end of the film leader is extremely
bent, straighten it or cut off the bent
portion.
• If you have pulled out too much film,
push it back into the cartridge to
reduce the slack.
5
Close the back cover.
6
Turn the main switch to [ON].
The film will advance to frame 1 automati-
cally, and the LCD panel will display the
exposure counter 1 and film status infor-
mation.
Incorrect film loading
If the film is not loaded
properly, the LCD panel
will display
. Open
the back cover and
load the film again.
Memo Memo
Memo Memo
Film leader end mark
Film retainer
20
Film status
information
Exposure counter
MZ-6(E)02 B/011-020 11/8/02 11:55 AM Page 20