Philips Digital Audio Satellite Receiver DR500 - Manual (Page 40)

DR500 (E-40)
Rev. C 10/94
Front Panel Status
Code
DMX/DJ Status
Message
DR500 Status
Individual Error Messages
000 System OK DR500 is working properly
001 System PLL Phased locked loop error
002 System LNB Power to the low noise block (LNB) is
shorted
004 System NV Nonvolatile memory errors
Combined Error Messages
003 System PLL
System LNB
Phased locked loop error and power to the
low noise block (LNB) is shorted
005 System PLL
System NV
Phased locked loop error and nonvolatile
memory errors
006 System LNB
System NV
Power to the low noise block (LNB) is
shorted and nonvolatile memory errors
007 System PLL
System LNB
System NV
All system errors are detected
For additional information about DR500 status messages, refer to Section 5: Maintenance and
Troubleshooting.
Maintenance
The DR500 Receiver and remote controls are designed to deliver years of maintenance-free, CD-quality
music. The only maintenance you may need to perform is cleaning your DR500 Receiver and replacing
batteries in your remote control.
Cleaning the DR500 Receiver
Before cleaning the DR500, unplug it from the wall outlet. Clean the cabinet, panel, and controls with a
soft cloth lightly moistened with water.
Do not use any type of abrasive pads, scouring powders, liquid cleaners, aerosol cleaners, or solvents such
as alcohol or benzene.