Pioneer DVR-LX70 - Manual (Page 107)

The Video Adjust menu
107
En
13
2 Move the cursor down and select
‘Detailed Settings’.
3 Select the picture quality setting you
want to adjust.
You can adjust the following settings:
• Prog. Motion – Adjusts the motion and
still picture quality when video output is
set to progressive. (Prog. Motion is
ineffective when PureCinema is On.)
• PureCinema – This setting optimizes the
picture for film material when the video
output is set to progressive. Usually set
to
Auto 1 but try switching to Auto 2,
On or Off if the picture appears
unnatural.
• Subtitle Adjust – When the video output
is set to progressive scan, it’s possible
that the subtitles in some movies will
disappear unnaturally. In this case
select the
On setting.
• YNR – Adjusts the amount of noise
reduction (NR) applied to the
Y (brightness) component.
• CNR – Adjusts the amount of noise
reduction (NR) applied to the C (colour)
component.
• BNR – Adjusts the amount of noise
reduction (NR) applied to the block noise
(artefacts visible in areas of flat colour,
caused by MPEG compression).
• MNR – Adjusts the amount of noise
reduction (NR) applied to the mosquito
noise (artefacts visible around the edges
of an image, caused by MPEG
compression).
• Sharpness High – Adjusts the
sharpness of the high-frequency
(detailed) elements in the picture.
• Sharpness Mid – Adjusts the sharpness
of the mid-frequency (less detailed)
elements in the picture.
• Detail – Adjusts how sharp edges
appear.
• White Level – Adjusts the intensity of
white.
• Black Level – Adjusts the intensity of
black.
• Black Setup – Corrects the standard
reference black level. The Black Setup
setting is only valid for NTSC video and
S-Video output signals.
• Gamma Correction – Adjusts the
brightness of darker images.
• Hue – Adjusts overall balance between
red and green.
• Chroma Level – Adjusts how rich the
colours appear.
• Chroma Delay – Adjust to correct the
gap between the Y and C components in
the video signal.
4 Use the / buttons to adjust the
currently selected picture quality setting.
5
When you have all the settings as you
want them, press HOME MENU to exit.
Tip
• To see more of the picture as you adjust
different settings, press ENTER after
selecting the setting you want to adjust.
Detailed Settings
Memory1
Memory1
Subtitle Adjust
Motion Still
PureCinma
Prog. Motion
Auto1
On
YNR
CNR
Max
Max
Off
Off
Max
Max
Off
Off
BNR
MNR
DVRLX70_TF_EN.book 107 ページ ２００７年８月１日 水曜日 午後４時１４分