Polaris Sportsman 550 EFI - Manual (Page 117)

113
MAINTENANCE
Battery
Your ATV may have either a sealed battery, which requires little mainte-
nance, or a conventional battery. A sealed battery can be identified by its
flat covers on the top of the battery. A conventional battery has six filler
caps on the top of the battery.
Always keep battery terminals and connections free of corrosion. If
cleaning is necessary, remove corrosion with a stiff wire brush. Wash
with a solution of one tablespoon baking soda and one cup water. Rinse
well with tap water and dry off with clean shop towels. Coat the termi-
nals with dielectric grease or petroleum jelly. Be careful not to allow
cleaning solution or tap water into a conventional battery.
Battery Removal
1. Remove the seat.
2. Disconnect the black (negative) battery cable first. Disconnect the
red (positive) battery cable last.
3. Disconnect the battery hold-down strap.
4. On conventional batteries, remove the battery vent tube.
5. Lift the battery out of the ATV. Be careful not to tip a conventional
battery sideways, which could spill electrolyte.
NOTICE: If electrolyte spills, immediately wash it off with a solution of one
tablespoon baking soda and one cup water to prevent damage to the
vehicle.