Philips CRT TV - Manual (Page 23)

23
Connect Accessory Devices
Equipment with Component Video Output Connectors
(DVD, Set Top Box,...)
&
Connect the cables of your Y-Pb-Pr equipment 1 to the Y-Pb-Pr input
AV1 IN sockets on the TV.
é
For reproduction of CVI (Component Video Input) and in order to have
correct picture reproduction, also connect a video cable to
VIDEO of AV1
2.
Note: This connection is used for
AV1 (CVBS) and for CVI sync.
“
Connect the Audio left and right (only for stereo equipment) cables 2 to
the
AUDIO L/ Mono and R input of AV1 .
Remark: Equipment may also be connected to the AV IN jacks ( AV3 ) at the right
side of the TV.
Equipment with Progressive Scan output (480p or 1080i 2 Fh)
Connect the equipment to the AV4 IN jacks on the TV.
See AV4 Digital HD input, below.
When you have digital equipment with a 480p or 1080i output (e.g. a digital
Set top Box or Progressive DVD player), connect it to the
AV4 IN VIDEO
1080i or 2 Fh PROGRESSIVE input.
Connect the equipment with 2 Fh RGB output to the RGB connector and to
the
L and R AUDIO jacks.
Connect the equipment with 2Fh Y, Pb, Pr output to the Y, Pb and Pr jacks
and to the
L and R AUDIO jacks.
See also the manual of your High Definition equipment.
Note: This television is designed to accept high definition signal standards 1080i and
480p as specified by the Electronic Industries Association standard EIA770.3.
Digital equipment from different manufacturers has the possibility of differing
output standards which may cause difficulties for the television to properly
display.
Warning: in case you notice scrolling images, wrong colors or no color, no picture, or
even combinations of these on your screen, check if the connections are done in
the right way.
The AV4 input can not be used to connect a computer or any other VGA device.
AV 4
in
VIDEO 1080i
2Fh PROGRESSIVE
Y
Pb
Pr
L
R
RGB
AUDIO
AV 2
in
AV 1
in
Monitor
out
COMPONENT VIDEO INPUT
VIDEO
L / Mono
R
Y
Pb
Pr
AUDIO S-VIDEO
1 2
DVD
AV4 Digital High Definition input