Pitney Bowes ADDRESSRIGHT DA550 - Manual (Page 39)

Pitney Bowes DA500/DA550 Operator Guide 3-11
DA500/DA550 Basics • 3
Setting Up A
Job
(continued) 3. Set the Feed Angle
The feed angle of the wireframe input stacker depends on
the type of material you're running:
• Heavy material: adjust to a low angle.
• Standard material: adjust to the center
(45 degree Angle).
• Light material: adjust to a high angle.
To make the adjustment:
1. Loosen the lock knob on the wireframe slide.
2. Move the wireframe up or down as required.
3. Tighten the lock knob to secure the wireframe.
Lock Knob
Wire Frame