Patton electronic 4020 Series - Manual (Page 72)

Localization 72
SmartLink 4020 Getting Started Guide 7 • System
Speed Dialing
Enables or disables the speed dialing feature.
Income Caller ID
Enables or disables the display of incoming caller ID feature.
Self Caller ID Block
Enables or disables the blocking of transmission of caller ID feature for outgoing calls.
Calling Prefix Keys
Calling Prefix Keys and other configuration parameters define the behavior of the calling feature.
Note Following function key must be start by ‘*’,’#’ character, or f (flash hook)
and follow a 1 or 2 numeric digit(s).
Figure 45. Calling Prefix Keys section of Localization Window
Call Return
Automatically places a call to the number of the last call received.
Warm Line
Configures the number to call automatically after a delay period once the telephone goes off hook. To config-
ure the warm line number enter the calling prefix key (*70 is the factory default), the number to dial and then
on hook the phone. You will hear a second dial tone after entering the calling prefix key. Before using warm-
line calling it must be enabled using the activate sequence defined in the supplementary service table.
Example:
*7013019751000 and on-hook the phone. When the handset is lifted, 301951000 will be called if another
number is not entered within the delay period specified under System > Localization.
Speed Dial
Configures speed dialing keys. To configure speed dialing numbers enter the calling prefix key (*71 is the fac-
tory default), the speed dial key, the number to dial and then on hook the phone. You will hear a second dial
tone after entering the calling prefix key. Speed dial calling must be enabled using the activate sequence defined
in the supplementary service table.
Example: