Patton electronic 4020 Series - Manual (Page 53)

Audio/CODEC Configuration 53
SmartLink 4020 Getting Started Guide 6 • Telephony
Audio/CODEC Configuration
Figure 29. Audio/CODEC Configuration window
CODECS
• Selected column: Check the codecs that are acceptable to use
• Silence Suppression column: Specifies whether silence suppression should be turned on in the
SmartLink 4020.
• Preferred-Codec column: Select the codec to be used as the first choice when encoding voice
Packetization
Configure the packet sending increment.
Jitter Buffer
Configure the timing of the voice buffering:
• Selection between adaptive or fixed jitter buffer. Default = ADAPTIVE.
• Set the adaptive jitter buffer maximum playout delay. Default = 100ms or Fixed jitter buffer playout delay.
Default = 40ms
• Whether or not to automatically switch from an adaptive jitter buffer to a fixed jitter buffer upon fax/
modem tone detection