ParaBody 425103 - Manual (Page 35)

35
STEP 41
0 1 2 3 4 5 6
1/2 1/2 1/2 1/2 1/2 1/2
• To assemble the LEG CABLE (101) follow the cable routing as shown and use the following steps:
• SECURELY attach the LEG CABLE (101) to the LEG CURL/EXT (15) using one 3/8 X 1-1/4” BOLT (83), one 3/8” WASHER
(91), and one 3/8” LOCK NUT (92). See FIGURE 41.
FIGURE 42
FIGURE 41
• Route the LEG CABLE (101) around the pulleys in the BASE (1) and through the floating pulley as shown in FIGURE 41.
STEP 42
• Run the LEG CABLE (101) through
the hole of the D-RING (7) and attach
one KEYHOLE CLEVIS (66) to the
end of the LEG CABLE (101). See
FIGURE 42.
66
1
91 15
101
92
83 3/8 X
1-1/4”
101
101
FLOATING
PULLEY
LAT CABLE
PRESS CABLE 7
101