Planet Technology Internet Telephony PBX System IPX-300 Series - Manual (Page 46)

Figure 4-28. Port trigger settings
Enable
Enable/Disable the port trigger, default setting is Disable.
Trigger Port
This is the port used to trigger the application. It can be either a single
port or a range of ports.
Trigger Type
This is the protocol used to trigger the special application.
Public Port
This is the port number on the WAN side that will be used to access
the application. You may define a single port or a range of ports. You
can use a comma to add multiple ports or port ranges.
Public Type This is the protocol used for the special application.
Action Insert a new Port Trigger or update a specified Port Trigger.
Table 4-12. Port trigger description
Packet Filter
Controlling access to a network by analyzing the incoming packets and letting they pass or halting them
based on the IP addresses of the source. (This function can be useful for residential screening as well –
for parental screening or other)
Figure 4-29. Packet filter settings
46