Pioneer 2TM - Manual (Page 80)

Appendix D: Serial Ethernet Settings
Appendix D
S ERIAL E THERNET S ETTINGS
The Ethernet-to-Serial device settings are made at the factory and stored in FLASH.
Pressing and holding the test button for more than five seconds restores those settings.
Server name: AMR-EW-1
Wireless
SSID: WaveLAN Network
Mode: Infrastructure
Speed: 1 Mbps
TCP/IP
Address: 192.168.1.11 (.12, .13, … for successive units on a single order)
Gateway: 192.168.1.1
Subnet mask: 255.255.255.0
Boot protocol: static
Serial Port (S1)
Disable console mode
Disable flow control
Serial port service (AMR-EW-1_S1)
Disable queuing
TCP port 8101
Disable NetWare
Misc Network
Disable AppleTalk
Disable POP3
Disable SMTP
LAN IP S ETTINGS
You need to modify your Ethernet-to-Serial device network setting in order to use it with
your own LAN and Access Point. You have two ways to change those settings: From a
serial console or from the device’s support webpage:
Console mode:
1. Power off