Polycom 4300T - Manual (Page 12)

User Guide V 2 IU 4300T Converged Network Appliance
1 - 4
Back Panel
The back panel of the 4300T contains the following (left to right):
• Power connector
• Erase button
• Power connector
• 4 switched LAN Ethernet ports
• Management console port
• T1 WAN port (RJ-48 with built-in CSU/DSU)
• Ethernet WAN port
Power Connector
The 4300T comes with an AC power cord and power adapter for connecting to
this port. Little force is necessary when the plug is properly positioned.
Erase Button
To erase any custom configuration and restore the 4300T to its factory default
state depress the erase button once and press again before 2 seconds expires.
Management console port
This port is used to establish a local console session with the 4300T using a
VT100 terminal or emulation program. The cable required is a
straight-through 8-wire cable. The serial port uses a baud rate of 9600, 8 data
bits, 1 stop bit and no parity.
EM002
Warning Using the Erase button as outlined above means any configuration made to the
4300T will be lost. Additionally the VoIP ALG registration code must be re-entered
in the 4300T as covered in Chapter 4: System Diagnostics, viewing the ALG
registration code. Erasing the configuration means that IP phones installed behind
the 4300T will not work and Internet connectivity or network access for PCs will be
down until the system is reconfigured.