Polycom 4300T - Manual (Page 116)

User Guide V 2 IU 4300T Converged Network Appliance
Regulatory Notices - 12
(1) This device must only be connected to the T1 WAN network.
(2) Before connecting your unit, you must inform the telephone company of
the following information:
Port ID REN/SOC FIC USOC
T1 WAN 04DU9-DN, 04DU9-BN 6.0N RJ48C
(3) If the unit appears to be malfunctioning, it should be disconnected from
the telephone lines until you learn if your equipment or the telephone line is
the source of the trouble. If your equipment needs repair, it should not be
reconnected until it is repaired.
(4) If the telephone company finds that this equipment is exceeding tolerable
parameters, the telephone company can temporarily disconnect service,
although they will attempt to give you advance notice if possible.
(5) Under the FCC Rules, no customer is authorized to repair this
equipment. This restriction applies regardless of whether the equipment is in
or out of warranty.
(6) If the telephone company alters their equipment in a manner that will
affect use of this device, they must give you advance warning so as to give you
the opportunity for uninterrupted service. You will be advised of your right to
file a complaint with the FCC.
(7) In the event of equipment malfunction, all repairs should be
performed by our Company or an authorized agent. It is the responsibility of
users requiring service to report the need for service to our Company or to one
of our authorized agents.
INDUSTRY CANADA (IC) NOTICE
NOTICE: This equipment meets the applicable Industry Canada Terminal
Equipment Technical Specifications. This is confirmed by the registration
number. The abbreviation, IC, before the registration number signifies that
registration was performed based on a Declaration of Conformity indicating
that Industry Canada technical specifications were met. It does not imply that
Industry Canada approved the equipment.”
Before installing this equipment, users should ensure that it is permissible to
be connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection.
The customer should be aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative
designated by the supplier. Any repairs or alterations made by a user to this
equipment, or equipment malfunctions, may give the telephone
communications company cause to request the user to disconnect the
equipment.