Polycom 3725-32870-002 - Manual (Page 70)

Chapter 6 – Appendix A – Telnet/Terminal Commands
6-2
If you entered a wrong password, you may be required to re-login to the
system.
If you entered the right password, you will be brought directly to the
command setting interface.
Command Introduction
Help
After logging into the system, you may enter ? or help after the prompt "#"
to show the command prompt information.
• “<>” indicates an optional parameter
• “{}” indicates a required parameter
• “|” indicates a 1-out-of-N parameter
Exit
Enter exit after the prompt # to exit the command control interface.
View Device Information
Enter show after the prompt # to view the current device information,
including the system information, license information, interface information
and IP address.
Idle Timeout Setting
Enter keepalive after the prompt # to modify the keep-live
timeout setting.
Table 6-1 Parameter Description
Parameter Description
timeout
Defaults to 120 seconds and can be modified to any value in
the range of 5 – 600 seconds
[Example] Set the timeout time to 60 seconds:
Reboot Device
Type "reboot" after the prompt "#" to restart the system. The system will
show the prompt message "Are you sure?". Type "Y" to restart the system, or
type "N" to cancel.