Pioneer VSX-520 - Manual (Page 42)

Using the tuner 06
42
En
1 Tune to a station you want to memorize.
See Listening to the radio on page 41 for more
on this.
2 Press TUNER EDIT.
The display shows PRESET, then a blinking
MEM and station preset.
3 Press PRESET / to select the station
preset you want.
You can also use the number buttons.
4 Press ENTER.
After pressing ENTER, the preset number stop
blinking and the receiver stores the station.
Listening to station presets
You will need to have some presets stored to do
this. See Saving station presets on page 41 if
you haven’t done this already.
• Press PRESET
/ to select the station
preset you want.
• You can also use the number buttons on
the remote control to recall the station
preset.
Naming preset stations
For easier identification, you can name all of
your preset stations.
1 Choose the station preset you want to
name.
See Listening to station presets above for how
to do this.
2 Press TUNER EDIT twice.
The cursor at the first character position is
blinking on the display.
3 Input the name you want.
Choose a name up to eight characters long.
• Use the PRESET / buttons to select
character position.
• Use the TUNE / buttons to select
characters.
• The name is stored when ENTER is
pressed.
Tip
• To erase a station name, follow steps 1 and
2, and press ENTER while the display is
blank. Press TUNER EDIT while the display
is blank, to keep the previous name.
• Once you have named a station preset,
Press DISP to show the name. When you
want to return to the frequency display,
press
DISP several times to show the
frequency.
VSX-520_UCSMXCN_En.book 42 ページ ２００９年１２月１５日 火曜日 午後２時３３分