Philips DSX 5540 - Manual (Page 10)

10
Connections (cont’d)
MODEL NUMBER: DSX 5540
Serial No : 81476039DSX 5540C Receiver ID No : 1234 5678 9012
DSX 5540 Only DSX 5540 Only
VHF/UHF
AUDIO
VIDEO Y
PB
PR
IN
Rear of TV
S-VIDEO IN
VHF/UHF
S-VIDEO IN
AUDIO
VIDEO
IN
Y
PB
PR
COMPONENT
IN
COMPONENT IN
Rear of
DIRECTV ® Receiver
A
C
B
D
Unplug all equipment from the AC outlet before making connections.
There are several options for connecting the video and audio outputs of your DIRECTV® Receiver, depending on the
type of equipment you want to connect and the quality of signal you want to achieve. The following chart summarizes
your options for video connections. Select either A, B, C or D and refer to the illustration and steps below to connect.
Option Video Signal Quality Video Output
A Excellent Component * (Y, PB, PR)
B Very Good S-VIDEO OUT
C Good VIDEO OUT1
D Standard TO TV/VCR
* DSX 5540 Only
Note: The TV rear jack panel shown above has jacks for all possible connections. Your TV’s rear jack panel may differ.
A. (For model DSX 5540 only.) Using a component cable (not included), connect the jacks on one end to the component
Y (green), PB (blue), PR (red) jacks on the rear of the Receiver. Connect the other ends to the TV’s COMPONENT
IN jacks. Select the proper input on your TV.
B. Using a S-VIDEO cable, connect one end to the S-VIDEO OUT jack on the Receiver to the S-VIDEO IN on the TV.
Select the proper input on your TV.
C. Using the RCA type connector (supplied), connect one end to the OUT 1 VIDEO jack (yellow) on the Receiver to the
VIDEO IN on the TV. Select the proper input on your TV.
D. Using the RF coaxial cable (supplied), connect one end to the TO TV/VCR jack on the Receiver to the RF IN jack on
the TV. Turn the TV on and select channel 3 or 4, whichever is not used or least used in your area. Set the
CHANNEL switch on the back of the Receiver to the same channel.
Video
DSX5500_5540 11/13/02 12:21 PM Page 10