Troubleshooting, Cont’d) – Philips DVDR615 User Manual
Page 68
68
English
3139 246 14221
Troubleshooting
(cont’d)
The index screen flickers
when a DVD+R is inserted.
Picture is fuzzy and
brightness varies when
copying DVD Video discs or
prerecorded video
cassettes.
The message ‘NO SIGNAL’
appears.
The message 'Recording of
minute' appears.
The message 'Insert
recordable disc' appears.
The message 'Maximum
number of timers reached'
appears.
The message 'Collision'
appears.
– You can finalize the disc using the following function:
1) Press OPEN/CLOSE on the DVD recorder to open the disc
tray.
2) Insert the disc but do not close the tray.
3) Hold down button number {4} on the remote control until the
tray closes. ‘FINALIZING' appears on the display panel.
4) If finalizing has been successful, the Picture Index screen will
appear.
– This happens if you try to copy DVDs or video cassettes that
have been copy-protected. Even though the picture on the TV is
fine, but the recording on a DVD+R(W) is faulty. This
interference is unavoidable with copy-protected DVDs or video
cassettes.
– The DVD+R(W) has recording lifetime, please change a new disc
for recording.
– Check that the cable is plugged in firmly.
– If a recording is made from a video recorder, change the tracking
on the video recorder.
– The DVD recorder may not be able to recognize the video input
signal if this signal is poor or does not comply with relevant
standards.
–
Select { Switch now } to switch the DVD recorder to standby
mode. A programmed timer recording will only start recording if
the DVD recorder is in standby mode.
–
Select { Suspend } will suspend the timer recording.
–
Select { Cancel recording } will cancel the timer recording.
–
Either no disc was inserted or a disc was inserted that cannot
be used for recordings. Insert a disc that can be recorded upon.
Locate on the disc the right position for the recording. Press
STOP button. Turn off the DVD recorder by pressing
STANDBY-ON button.
–
It has reached the maximum programmed, no more recordings
are allowed. Press TIMER button, select the programmed
recording (TIMER block) you want to check or clear using 3 4
button.
–
The timer recording overlaps with another timer recording.
–
If you ignore this warning, the programmed recording with the
early start time will start first.
The second recording will then lack the beginning.
–
Change the information for one of the two recordings.
–
Delete one of the two recordings.
Problem
Solution
DVDR610_615_37_Engfinal434
8/16/04, 4:12 PM
68