Philips Laserfax LPF 5120 - Manual (Page 52)

52 Philips · Laserfax 5120 · 5125 · 5135
EN
1 Insert a white piece of paper into the document feeder.
2 Press OK, 931 and OK.
3 Confirm with OK.
4 Wait until calibration is completed and the device
returns to starting mode.
Using Service Codes
Introduction
The service codes delete all the changed settings and your
device is reset to factory settings. It may be possible that the
device with the changed settings reacts differently than
expected.
Using Service Codes
1 Press OK, 933 and OK.
2 Enter a service code:
70015
—Deletes all changed settings.
Saved data and telephone book entries remain intact.
70026
—Deletes saved faxes, when there
are problems with printing.
3 Confirm with OK.
4 Using [ select SURE: YES.
5 Confirm with OK.
Spaltenumbruch
Power Cycling
Power Cycling
If a problem occurs that cannot be corrected with the
instructions in this user manual (see also the help below),
follow the steps given here.
1 Switch the device off using the on/off switch on the
rear.
2 Wait at least ten seconds.
3 Switch the device on using the on/off switch on the
rear.
4 Follow the instructions on the display. If the problems
repeats, please contact our technical customer service or
your retailer.
Spaltenumbruch
CAUTION!
Settings will be Deleted!
Only use the service codes if this is absolutely
necessary. Some service codes also delete saved
messages and telephone book entries.
Notice
Cancelling Entry
If you have entered the incorrect code, you
can cancel the entry with SURE: NO.
lpf-5120-5125-5135-manual-uk-int-253117544-b.book Seite 52 Mittwoch, 16. Dezember 2009 10:01 10